Tried to upgrade the firmware on my rpi4 running phoscon and the update consistently fails with the following. sudo GCFFlasher_internal -t 60 -f deCONZ_RaspBeeII_0x26720700.bin.GCF GCFFlasher V3_17 (c) dresden elektronik ingenieurtechnik gmbh Reboot device RaspBee (RaspBee) deCONZ firmware vers…

[image] ChrisHae: Possible that the devices were not responsible because of interferences that are caused by USB3 adapters. To prevent those interferences it is recommended to use an USB extension cable or use the USB2 port. the thing with the raspbee is that its harder to do so.

[image] Mimiix: the thing with the raspbee is that its harder to do so. I mean the USB Stick or portable hdd/ssd’s

Having the same problem. I am using: Raspbee II/deconz 2.12.6 stable RPi 4B/4GB RAM No USB devices, original power supply Firmware-Upgrade to the latest stable Firmware produce the same messages/behavior as above mentioned by rutteger. Downgrade to the initial Firmware provides these logs: su…

deCONZ --dbg-info=2 --dbg-zdp=1 --dbg-zcl=1 --db-aps=1 --dbg-http=1 Can you add logs with: deCONZ --dbg-info=2 ----db-aps=2 --dbg-error=2 And just wondering: What Case do you have with the raspbee?

Thanks for the response. I’m sorry for not making myself clear. I carried out a firmware upgrade, obtaining the same message as mentioned above rutteger. I get exact the same behaviour as rutteger described at October 12th. After the firmware update, that seem to fail I see the new firmware with t…

There are the logs. Thanks in advance. 21:41:01:056 Sqlite sensors: sid = 62 21:41:01:056 Sqlite sensors: name = Temperaturregler Wohnzimmer West 21:41:01:056 Sqlite sensors: type = ZHAThermostat 21:41:01:056 Sqlite sensors: modelid = SPZB0001 21:41:01:056 Sqlite sensors: manufacturername = Eur…

This starting log seem fine. and after you have the disconnect error ? (BTW try to use third site like pastebon to share log)

I dont see any APS logs there. Can you please use Pastebin for new logs?

On yesterday I tried to start from the scratch with a fresh image. Then I recognized, that a pairing is possible after a reset of devices/nodes. So I started beginning reseting the 45 devices. Till now no problems. Thanks for getting in touch.

Hi, I’m currently experiencing sort of the same problem, but I think it can’t be narrowed down to the firmware update… I ran an apt upgrade on my RPi with Raspbian image on 15.11.21 (something I haven’t done for a long time before then). After that deCONZ was updated to version 2.12.06 and additio…

deCONZ Community

Rasbee II not working after firmware upgrade

deCONZ General Support

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled