# Problem with call next scene

**URL:** <https://forum.phoscon.de/t/problem-with-call-next-scene/5112>\
**Category:** Advice\
**Created:** [September 5, 2024, 8:41am UTC](https://forum.phoscon.de/t/problem-with-call-next-scene/5112 "2024-09-05T08:41:41Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![faltings](https://forum.phoscon.de/letter_avatar_proxy/v4/letter/f/47e85d/32.png) [@faltings](https://forum.phoscon.de/u/faltings)\
**Post date:** [September 5, 2024, 8:41am UTC](https://forum.phoscon.de/t/problem-with-call-next-scene/5112/1 "2024-09-05T08:41:41Z")

</div>

Hello, I am running an installation with about 100 devices using a Conbee II on a Pi 4.

I have a group with 2 lights controlled by Kobold dimmers, and 4 scenes with the different combinations of the 2 lights on and off. I use a single Gira Switch button to go from one scene to the next, using “call next scene” in the switch editor.  
When I cycle through the scenes by pushing the button, I can see in the Phoscon app that it goes through the scenes 00 - 11 - 01 - 10 - 00 correctly.

However when it goes from 01 to 10, the lights do not change (i.e. stay at 01). When I tap on the 10 scene on the app, the lights change just fine with no delay, so the scene is there correctly.

It seems that when I call the next scene, the signals occasionally (and repeatedly) get lost.  
Is there a way to avoid this behavior?

Thanks for your help!