I’ve updated do 13.0.01 and am not able to pair Hue Motion Sensor. After adding a device to Deconz via Phoscon it’s Not reachable for all the times but it have good route connection. I have a few Hue & Aqara sensors but only this new one have a problems. That sensor is very close about 4 routers …

Conbee II firmware is updated => 26720700 Philips Hue Motion is still in Not reachable status. I’ve deleted and pair again this device.

Are you still see the 0xE1 error? At its extension the ConBee II should have distance to USB devices, SSD, metal, radio, routers or other electronics. In case of seeing the 0xE1 error, a different position of the ConBee II can bring improvements even if the current position seems optimal.

How would a firmware fix a non reachable issue? The 0xe1 needs to be solved before seeking anywhere else.

I paried a sensor close to Conbee II (about 5cm away). Move to the destination place and it’s seems to work. It’s wired because I have a lot of devices which is so far from Conbee or other routers. This sensor is in the middle of the house. But thanks for your time and help @Mimiix @ich

We investigate here, please be patient.

Hi, have similar issues with three Hue Outdoor Motion sensors I’ve purchased recently. I’ll try to list configuration, logs etc below for troubleshooting. I’ve managed to pair by upgrading ConBee II (26720700) and reverting Docker image used to marthoc/deconz:stable (2.12.06) and performing multi…

[image] ich: host system (Raspberry Pi 3B+ / 4B / PC / NAS): RasPi 4 execution method (Raspbian / Ubuntu / Home Assistant deCONZ add-on / Marthoc Docker container / Windows / Virtual Machine): Answer: Raspbian firmware version (format 26xxyy00): Answer: 26720700 deCONZ Version (Format 2.xx.y…

Forgot … My Map [image] ConBee II is next to the hue sensor … maybe 2cm away on my desktop Comunication seems to be possible: ame":“VPIR Schlafzimmer”,“state”:{“lastupdated”:“2021-10-25T17:39:39.785”,“presence”:false},“swversion”:“1.0”,“type”:“CLIPPresence”,“uniqueid”:“vpir-1634987948278”},“55”…

Same problem here with my first attempt to pair a Hue Motion Sensor. It’s also on Version on 6.1.1.27575 as @MartinNue host system (Raspberry Pi 3B+ / 4B / PC / NAS): PC execution method (Raspbian / Ubuntu / Home Assistant deCONZ add-on / Marthoc Docker container / Windows / Virtual Machine): A…

deCONZ Community

Fresh paired Hue Motion Sensor is not reachable

deCONZ General Support

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled