# Bad Connections

**URL:** <https://forum.phoscon.de/t/bad-connections/543>\
**Category:** General Support\
**Created:** [September 30, 2021, 6:47am UTC](https://forum.phoscon.de/t/bad-connections/543 "2021-09-30T06:47:42Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![MBM1982](https://forum.phoscon.de/letter_avatar_proxy/v4/letter/m/e274bd/32.png) [@MBM1982](https://forum.phoscon.de/u/MBM1982)\
**Post date:** [September 30, 2021, 6:47am UTC](https://forum.phoscon.de/t/bad-connections/543/1 "2021-09-30T06:47:42Z")

</div>

Hi there,

I am running a Conbee II on a raspberry pi with deconz gui.

When I restart the RPI all battery powered devices get connected to the nearest ac powered device.  
After a while I recognize some lags in motion detectors and /or switches.  
After having a look into the gui I discovery some bad connections, which I don’t know why.  
See screenshot.  
The “Licht Schuppen” is outside in a shed, so probably the worst connection possible.  
I tried to organize it so it is a bit according to distances in real life

How can I get the two marked devices to connect to a closer ac powered device?

THX Martin

P.S. My lights are still connected to Alexa since I am not able to connect the Conbee with Alexa (maybe a Fritzbox issue)

 ![deconzgui.PNG](https://forum.phoscon.de/uploads/default/original/1X/2179070f83b48445f8a6cf2b8e11ef1832d14c9e.jpeg)

---

<div class="post-metadata">

**Author:** ![Gautama](https://forum.phoscon.de/user_avatar/forum.phoscon.de/gautama/32/20_2.png) [@Gautama](https://forum.phoscon.de/u/Gautama)\
**Post date:** [September 30, 2021, 8:34am UTC](https://forum.phoscon.de/t/bad-connections/543/2 "2021-09-30T08:34:56Z")

</div>

Hey @MBM1982.

first of all: make sure youre software is up 2 date. The latest deCONZ is 2.12.06, the latest Firmware for the ConBee II is 26720700.

You can try source routing over deCONZ:

 ![source routing](https://forum.phoscon.de/uploads/default/original/1X/bea87e077f0d4f10b3eab83d77e439eebeab8b6c.png)

Click there on “Enable Souce Routing”

Please note that this will take a while.  
Let me know how it goes.

---

<div class="post-metadata">

**Author:** ![MBM1982](https://forum.phoscon.de/letter_avatar_proxy/v4/letter/m/e274bd/32.png) [@MBM1982](https://forum.phoscon.de/u/MBM1982)\
**Post date:** [November 2, 2021, 5:21pm UTC](https://forum.phoscon.de/t/bad-connections/543/3 "2021-11-02T17:21:14Z")

</div>

Hi,

so I tried a couple of things (after the holidays), but I think Source Routing is only for powered devices.  
Since I installed 40 further lamps, a lot of new connections established. So no problem anymore with one bad connection 😅

THX
